Cole Markham b4bdebab9a Meira updates for bluetooth and audio (#2731) 7 gadi atpakaļ
..
featherble b4bdebab9a Meira updates for bluetooth and audio (#2731) 7 gadi atpakaļ
keymaps b4bdebab9a Meira updates for bluetooth and audio (#2731) 7 gadi atpakaļ
promicro b4bdebab9a Meira updates for bluetooth and audio (#2731) 7 gadi atpakaļ
TWIlib.c a9a46adba0 Add support for Meira 7 gadi atpakaļ
TWIlib.h a9a46adba0 Add support for Meira 7 gadi atpakaļ
config.h b4bdebab9a Meira updates for bluetooth and audio (#2731) 7 gadi atpakaļ
issi.c a9a46adba0 Add support for Meira 7 gadi atpakaļ
issi.h a9a46adba0 Add support for Meira 7 gadi atpakaļ
lighting.c bd1ad405bf Update Meira for revision 1.1 to enable backlighting by default (#2468) 7 gadi atpakaļ
lighting.h a9a46adba0 Add support for Meira 7 gadi atpakaļ
matrix.c 84a713b05c Remove _quantum functions from custom matrix.c code 7 gadi atpakaļ
meira.c b4bdebab9a Meira updates for bluetooth and audio (#2731) 7 gadi atpakaļ
meira.h b4bdebab9a Meira updates for bluetooth and audio (#2731) 7 gadi atpakaļ
readme.md f74f0ac06b Update Meira readme 7 gadi atpakaļ
rules.mk b4bdebab9a Meira updates for bluetooth and audio (#2731) 7 gadi atpakaļ

readme.md

Meira

Miera

A 4x12 ortholinear low-profile keyboard.

Keyboard Maintainer: Cole Markham
Hardware Supported: Meira/ProMicro, Meira/FeatherBLE
Hardware Availability: WoodKeys.click

Two controllers are support: the Pro Micro, and the Adafruit Feather BLE 32u4. Support for each is defined as a hardware revision subfolder in QMK. Main differences include processor frequencies and matrix pinouts.

Make example for this keyboard (after setting up your build environment):

make meira/promicro:default

or

make meira/featherble:default

See build environment setup then the make instructions for more information on generic QMK configuration and setup.

Both the Pro Micro and the Feather BLE use the Catalina bootloader, which is typically programmed using avrdude.

Matrix

In order to have enough pins for the matrix and other functions, a custom matrix is implemented using a demultiplexer to scan the columns. Since the demux is active low, the diodes must be oriented with the cathode connected to the demux pin. When looking at the bottom of the board with the controller at the top right, the cathode mark on the diode should be toward the left.

LED Controller

The in-switch LEDs are driven by an ISSI LED controller (IS31FL3731). The micro controller communicates with this chip using I2C. Individual LED control is possible, but currently only general backlighting support is implemented. This functionality is located in lighting.c, issi.c, and TWILib.c.