Ryan 7cbff9d921 Deprecate `KC_LOCK` for `QK_LOCK` (#18796) 2 yıl önce
..
keymaps 7cbff9d921 Deprecate `KC_LOCK` for `QK_LOCK` (#18796) 2 yıl önce
config.h 55b9a4d06e Remove RGBLIGHT_ANIMATION and clean up effect defines for G-K (#18726) 2 yıl önce
info.json 2d778d2ff2 Move keyboard USB IDs and strings to data driven: handwired (#17822) 2 yıl önce
readme.md d2accb48e7 RESET -> QK_BOOT keyboard readme (#18110) 2 yıl önce
rules.mk 18490537a5 [Keyboard] Add Snatchpad keyboard (#16330) 3 yıl önce
snatchpad.c 18490537a5 [Keyboard] Add Snatchpad keyboard (#16330) 3 yıl önce
snatchpad.h 18490537a5 [Keyboard] Add Snatchpad keyboard (#16330) 3 yıl önce

readme.md

snatchpad

snatchpad etch-a-sketch macropad

A 6-key macropad with 2 rotary encoders intended for use as a pointing device.

In addition to the 3d printed parts and microcontroller, the following hardware is required:

  • 4 * 3x3 mm threaded inserts
  • 4 * 4mm M3 bolt
  • USB daughter board

  • Keyboard Maintainer: xia0
  • Hardware Supported: e.g. Arduino Pro Micro
  • Hardware Availability: github

Make example for this keyboard (after setting up your build environment):

make handwired/snatchpad:default

Flashing example for this keyboard:

make handwired/snatchpad:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
  • Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available