|
vor 5 Jahren | |
---|---|---|
.. | ||
keymaps | f14629ed1c Remove/migrate action_get_macro()s from default keymaps (#5625) | vor 5 Jahren |
config.h | faaaa134fd Replace DEBOUNCING_DELAY (deprecated) with DEBOUNCE (#5997) | vor 6 Jahren |
info.json | eccfb8d55e SixKeyBoard refactor (#3193) | vor 7 Jahren |
matrix.c | 8680c50d07 Removes Erez personally from QMK (#5883) | vor 6 Jahren |
readme.md | c8cbee5d71 Modified URLs to point to new locations | vor 6 Jahren |
rules.mk | d2e1cc4d48 Trim firmware sizes from default rules.mk, part 3 (#8045) | vor 5 Jahren |
sixkeyboard.c | 13bb6b4b7f Backlight abstraction and other changes (#439) | vor 9 Jahren |
sixkeyboard.h | eccfb8d55e SixKeyBoard refactor (#3193) | vor 7 Jahren |
Keyboard Maintainer: QMK Community
Hardware Supported: Techkeys SixKeyBoard PCB
Hardware Availability: Techkeys
Make example for this keyboard (after setting up your build environment):
make sixkeyboard:default
See build environment setup then the make instructions for more information.
The schematic is like this:
switches leds
,--+--+--. ,--+--+--.
|C7|B7|B5| |C6|B6|B4|
+--+--+--+ +--+--+--+
|D6|D1|D4| |D5|D2|D3|
`--+--+--' `--+--+--'
The LED on the bottom is C4
. All 7 of the leds are turned on when the keyboard boots-up in the sixkeyboard.c
file - backlight_enable is not required. The MCU is an Atmega16u2, so the flash memory is limited to 0x3000 bytes - the current setup uses just about all of that! I'm sure things can be opitimised a bit.
There is a jumper on the bottom of the board (next to the USB port) that serves as a reset button - I drilled a hole in my case to allow for quick access via a screwdriver/metal object.